D-Link DGS-1510 Series - Page 111

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
108
8-26 show radius statistics
This command is used to display RADIUS statistics for accounting and authentication packets.
show radius statistics
Parameters
None.
Default
None.
Command Mode
Privilege EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display statistics counters related to servers.
Example
This example shows how to display the server related statistics counters.
Switch#show radius statistics
RADIUS Server: 172.19.192.80: Auth-Port 1645, Acct-Port 1646
State is UP
Auth. Acct.
Round Trip Time: 10 10
Access Requests: 4 NA
Access Accepts: 0 NA
Access Rejects: 4 NA
Access Challenges: 0 NA
Acct Request: NA 3
Acct Response: NA 3
Retransmissions: 0 0
Malformed Responses: 0 0
Bad Authenticators: 0 0
Pending Requests: 0 0
Timeouts: 0 0
Unknown Types: 0 0
Packets Dropped: 0 0
Display Parameters
Auth.
Statistics for authentication packets.
Acct.
Statistics for accounting packets.
Round Trip Time
The time interval (in hundredths of a second) between the most
recent Response and the Request that matched it from this
RADIUS server.
Access Requests
The number of RADIUS Access-Request packets sent to this
server. This does not include retransmissions.
Access Accepts
The number of RADIUS Access-Accept packets (valid or invalid)
received from this server.
Access Rejects
The number of RADIUS Access-Reject packets (valid or invalid)