D-Link DGS-1510 Series - Page 124

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
121
no ipv6 enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the IPv6 address is explicitly configured on the interface, the IPv6 link-local address is
automatically generated and the IPv6 processing is started. When the interface has no IPv6 address
explicitly configured, the IPv6 link-local address is not generated and the IPv6 processing is not
started. Use the ipv6 enable command to auto-generate the IPv6 link-local address and start the IPv6
processing on the interface.
Example
This example shows how to enable IPv6 on interface VLAN 1, which has no IPv6 address explicitly
configured.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 enable
Switch(config-if)#
10-6 ipv6 neighbor
This command is used to create a static ipv6 neighbor entry. Use the no form of this command to
delete a static IPv6 neighbor entry.
ipv6 neighbor IPV6-ADDRESS INTERFACE-ID MAC-ADDRESS
no ipv6 neighbor IPV6-ADDRESS INTERFACE-ID
Parameters
IPV6-ADDRESS
Specifies the IPv6 address of the IPv6 neighbor cache entry.
INTERFACE-ID
Specifies the interface for creating the static IPv6 neighbor cache
entry.
MAC-ADDRESS
Specifies the MAC address of the IPv6 neighbor cache entry.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline