D-Link DGS-1510 Series - Page 130

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
127
Switch#show spanning-tree bpdu-protection
Global State: Enabled
Interface State Mode Status
-------------- -------- -------- ------------
eth1/0/1 Enabled Block Normal
eth1/0/2 Disabled Shutdown Normal
eth1/0/3 Disabled Shutdown Normal
eth1/0/4 Disabled Shutdown Normal
eth1/0/5 Disabled Shutdown Normal
eth1/0/6 Disabled Shutdown Normal
eth1/0/7 Disabled Shutdown Normal
eth1/0/8 Disabled Shutdown Normal
eth1/0/9 Disabled Shutdown Normal
eth1/0/10 Disabled Shutdown Normal
eth1/0/11 Disabled Shutdown Normal
eth1/0/12 Disabled Shutdown Normal
eth1/0/13 Disabled Shutdown Normal
eth1/0/14 Disabled Shutdown Normal
eth1/0/15 Disabled Shutdown Normal
eth1/0/16 Disabled Shutdown Normal
eth1/0/17 Disabled Shutdown Normal
eth1/0/18 Disabled Shutdown Normal
eth1/0/19 Disabled Shutdown Normal
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
This example shows how to display the BPDU attack protection status of interface eth1/0/1.
Switch#show spanning-tree bpdu-protection interface eth1/0/1
Interface State Mode Status
-------------- -------- -------- ------------
eth1/0/1 Enabled Block Normal
Switch#
11-4 snmp-server enable traps stp-bpdu-protection
This command is used to enable the sending of the SNMP notifications for BPDU protection. Use the
no form of this command to disable the sending of the SNMP notifications for BPDU protection.
snmp-server enable traps stp-bpdu-protection
no snmp-server enable traps stp-bpdu-protection
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level