D-Link DGS-1510 Series - Page 134

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
131
interface INTERFACE-ID
Specifies the interface’s ID. The acceptable interface will be a
physical port.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
-
(Optional) Specifies a range of interfaces. No space before and
after the hyphen.
Default
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to clear the test results for the cable diagnostics. If the test is running on the
interface, an error message will be displayed.
Example
This example shows how to clear the test results for the cable diagnostics.
Switch# clear cable-diagnostics interface eth1/0/1
Switch#