D-Link DGS-1510 Series - Page 139

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
136
This example shows how to clear the debug buffer information.
Switch# debug clear buffer
Switch#
14-6 debug clear error-log
This command is used to clear the error log information.
debug clear error-log
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to clear the error log information.
Example
This example shows how to clear the error log information.
Switch# debug clear error-log
Switch#
14-7 debug show buffer
This command is used to display the content of the debug buffer or utilization information of the debug
buffer.
debug show buffer [utilization]
Parameters
utilization
(Optional) Specifies to display the utilization of the debug buffer. If
not specified, this will display the content in the buffer.
Default
None.
Command Mode
Privileged EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline