D-Link DGS-1510 Series - Page 15

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
12
User EXEC Mode.
Privilege EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
Execute this command if the current level is lower than the command level. If the privileged level
requires a password, enter it in the field provided. However, only three attempts are allowed. Failure
to access this level returns the user to the current level.
Example
This example shows how to enter the Privileged EXEC Mode.
Switch# enable 15
password:***
Switch#
2-3 disable
This command is used to downgrade to a level lower user level than the privileged level.
disable [PRIVILEGE-LEVEL]
Parameters
PRIVILEGE LEVEL
Specifies the privilege level to enter. If not specified, level 1 is used.
Default
None.
Command Mode
User EXEC Mode.
Privilege EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to enter the privilege level, which is lower than the current level. When using this
command to enter the privilege level, that has a password configured, no password is needed.
Example
This example shows how to logout.
Switch# disable
Switch> logout
2-4 configure terminal
This command is used to enter the Global Configuration Mode.
configure terminal