D-Link DGS-1510 Series - Page 161

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
158
Vendor3
Specifies to use vendor 3.
Default
The Switch's system MAC address is used as the remote ID string.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to select different vendor’s remote ID format or configures a user-defined
string of ASCII characters to be the remote ID.
Example
This example shows how to use vendor2 as the remote ID.
Switch# configure terminal
Switch(config)# ip dhcp relay information option
Switch(config)# ip dhcp relay information option format remote-id vendor2
Switch(config)#
This example shows how to configure a user-defined string “switch1” as the remote ID.
Switch# configure terminal
Switch(config)# ip dhcp relay information option
Switch(config)# ip dhcp relay information option format remote-id string switch1
Switch(config)#
17-11 ip dhcp relay information option format-type remote-id
This command is used to configure the DHCP information remote ID sub-option of vendor format
string in interface configuration mode.
ip dhcp relay information option format-type remote-id vendor3 string STRING
no ip dhcp relay information option format-type remote-id vendor3
Parameters
Vendor3
Specifies the vendor 3 user-defined string with the maximum 32
characters.
STRING
Specifies the user-defined string.
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline