D-Link DGS-1510 Series - Page 175

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
172
Use this command to save the DHCP snooping binding database in the stack switch. The database is
not saved in a stack member switch.
The lease time of the entry will not be modified and the live time will continue to be counted while the
entry is provisioned.
Example
This example shows how to store the binding entry to a file in the file system.
Switch# configure terminal
Switch(config)# ip dhcp snooping database tftp: //10.0.0.2/store/dhcp-snp-bind
Switch(config)#
18-4 clear ip dhcp snooping database statistics
This command is used to clear the DHCP binding database statistics.
clear ip dhcp snooping database statistics
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
When you enter this command, the Switch will clear the database statistics.
Example
This example shows how to clear the snooping database statistics.
Switch# clear ip dhcp snooping database statistics
Switch#
18-5 clear ip dhcp snooping binding
This command is used to clear the DHCP binding entry.
clear ip dhcp snooping binding [MAC-ADDRESS] [IP-ADDRESS] [vlan VLAN-ID] [interface
INTERFACE-ID]
Parameters
MAC-ADDRESS
Specifies the MAC address to clear.
IP-ADDRESS
Specifies the IP address to clear.
vlan VLAN-ID
Specifies the VLAN ID to clear.
interface INTERFACE-ID
Specifies the interface to clear.