D-Link DGS-1510 Series - Page 182

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
179
18-14 show ip dhcp snooping
This command is used to display the DHCP snooping configuration.
show ip dhcp snooping
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display DHCP snooping configuration settings.
Example
This example shows how to display DHCP snooping configuration settings.
Switch# show ip dhcp snooping
DHCP Snooping is enabled
DHCP Snooping is enabled on VLANs:
10, 15-18
Verification of MAC address is disabled
Information option of allowed on un-trusted interface is disabled
Interface Trusted Rate Limit
------------ ---------- ------------
eth3/0/1 no 10
eth3/0/8 no 50
eth3/0/9 yes no_limit
Switch#
18-15 show ip dhcp snooping binding
This command is used to display DHCP snooping binding entries.
show ip dhcp snooping binding [IP-ADDRESS] [MAC-ADDRESS] [vlan VLAN-ID] [interface
[INTERFACE-ID [, | -]]]
Parameters
IP-ADDRESS
(Optional) Specifies to display the binding entry based on the IP
address.
MAC-ADDRESS
(Optional) Specifies to display the binding entry based on the MAC
address.