DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
204
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Only SFP/SFP+ port interfaces with optical modules, with transceiver monitoring capability, are valid
for this configuration.
This command configures the RX power thresholds on the specified port. This value will be stored
both in the system and in the SFP/SFP+ transceivers and be converted to the 16-bit format and then
written into the SFP module.
If the SFP module configured does not support the threshold change, the user-configured threshold is
just stored in the system and the displayed value will be the user-configured threshold. If there is no
user-configured threshold, the displayed value will always reflect the factory preset value defined by
the vendor.
The no form of this command has the effect to clear the configured threshold stored in system. It does
not change the threshold stored in the SFP/SFP+ transceivers. Use the no form of this command to
prevent threshold values in newly inserted SFP/SFP+ transceivers from being altered.
Example
This example shows how to configure the RX power low warning threshold as 0.135 mW on interface
eth3/0/1.
Switch# configure terminal
Switch(config)# transceiver-monitoring rx-power eth3/0/1 low warning mwatt 0.135
Switch(config)#
22-7 transceiver-monitoring temperature
This command is used to configure the temperature thresholds for the specified port. Use the no form
of this command to remove the configuration.
transceiver-monitoring temperature INTERFACE-ID {high | low} {alarm | warning} VALUE
no transceiver-monitoring temperature INTERFACE-ID {high | low} {alarm | warning}
Parameters
To Next Page
Loading...
