D-Link DGS-1510 Series - Page 22

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
19
2-12 show unit
This command is used to display information about system units.
show unit [UNIT-ID]
Parameters
UNIT-ID
(Optional) Specify the unit to display.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays information about the system modules. If no option is specified, then all of
units’ information will be displayed.
Example
This example shows how to display the information about units on a system.
Switch#show unit
Unit Model Descr Model Name
---- ------------------------------------------- ------------------
1 No module description DGS-1510-28P
Unit Serial-Number Status Up Time
---- --------------------------------- --------- -----------------
1 ok 0DT6H32M18S
Unit Memory Total Used Free
---- -------- ---------- ---------- ----------
1 DRAM 131072 K 66567 K 64505 K
1 FLASH 29937 K 7799 K 22138 K
Switch#
2-13 show cpu utilization
This command is used to display the CPU utilization information.
show cpu utilization
Parameters
None.
Default
None.