D-Link DGS-1510 Series - Page 240

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
237
Command Default Level
Level: 12.
Usage Guideline
This command is used to create, modify or delete an ITU-T G.8032 ERP physical ring and enter the
ERP configuration mode.
Example
This example shows how to create an ERP ring named “campus”.
Switch#configure terminal
Switch(config)#ethernet ring g8032 campus
Switch(config-erp)#
28-3 ethernet ring g8032 profile
This command is used to create or modify a G.8032 profile and enter the ERP profile configuration
mode. Use the no form of this command to delete the specified profile.
ethernet ring g8032 profile PROFILE-NAME
no ethernet ring g8032 profile PROFILE-NAME
Parameters
PROFILE-NAME
Specifies the name of the G.8032 profile with the maximum of 32
characters.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create, modify or delete a G.8032 profile and enter the ERP profile
configuration mode.
Example
This example shows how to create a G.8032 profile named “campus”.
Switch#configure terminal
Switch(config)#ethernet ring g8032 profile campus
Switch(config-g8032-ring-profile)#
28-4 tcn-propagation
This command is used to enable the propagation of the topology change notifications from the sub-
ERP instance to the major instance. Use the no form of this command to disable the function.
tcn-propagation
no tcn-propagation