D-Link DGS-1510 Series - Page 26

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
23
level PRIVILEGE-LEVEL
Specifies the level of the execution right. The value is from 1 to 15.
reset
Specifies to revert the command to the default setting level.
COMMAND-STRING
Specifies the command to be changed.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to configure the execution rights of a command string to a privilege level.
When this command is used, the command string used must exist at current command level. When
more than one command begins with the command string specified, all of the commands starting with
that command string will be changed to the specified command level.
Example
This example shows how to configure the configure terminal command string as a level 1 command.
Switch#configure terminal
Switch(config)#privilege exec level 1 configure terminal
Switch(config)#
2-18 show privilege
This command is used to display current privilege level.
show privilege
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display current privilege level.
Example
This example shows how to display the current privilege level.
Switch# Switch#show privilege
Current privilege level is 15
Switch#