DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
257
30-4 mac-address-table learning
This command is used to enable MAC address learning on the physical port. Use the no form of this
command to disable learning.
mac-address-table learning interface INTERFACE-ID [, | -]
no mac-address-table learning interface INTERFACE-ID [, | -]
Parameters
(Optional) Specifies the physical port interface to be configured.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this commands to enable or disable MAC address learning on a physical port.
Example
This example shows how to enable the MAC address learning option.
Switch# configure terminal
Switch(config)# mac-address-table learning interface eth1/0/5
Switch(config)#
30-5 mac-address-table notification change
This command is used to enable or configure the MAC address notification function. Use the no form
of this command to disable the function or set the optional configuration to default.
mac-address-table notification change [interval SECONDS | history-size VALUE]
no mac-address-table notification change [interval | history-size]
Parameters
(Optional) Specifies the interval of sending the MAC address trap
message. The range is 1 to 2147483647 and the default value is 1
second.
(Optional) Specifies the maximum number of the entries in the MAC
history notification table. The range is 0 to 500 and the default value
is 1 entry.
To Next Page
Loading...
