D-Link DGS-1510 Series - Page 273

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
270
Parameters
all
Specifies that all VLANs are advertised on the interface.
add
(Optional) Specifies a VLAN or a list VLANs to be added to
advertise the VLAN list.
remove
(Optional) Specifies a VLAN or a list VLANs to be removed from the
advertised VLAN list.
VLAN-ID [,|-]
(Optional) Specified the advertise VLAN list or the VLAN list to be
added to or removed from the advertise VLAN list. If the add or
remove parameter is not specified, the specified VLAN list
overwrites the advertise VLAN list. The range is 1 to 4094.
,
(Optional) Specifies a series of VLANs, or separate a range of
VLANs from a previous range. No spaces are required before and
after the comma.
-
(Optional) Specifies a range of VLANs. No spaces are required
before and after the hyphen.
Default
By default, no VLANs are advertised.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for both physical ports and port-channel interface configuration.
Administrators can use the gvrp advertise command to enable the specified VLANs’ GVRP advertise
function on the specified interface. The command only takes effect when GVRP is enabled. The
command only takes effect for hybrid mode and trunk mode.
Example
This example shows how to enable the advertise function of VLAN 1000 on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# gvrp advertise 1000
Switch(config-if)#
31-5 gvrp vlan create
This command is used to enable dynamic VLAN creation. Use the no form of this command to disable
the dynamic VLAN creation function.
gvrp vlan create
no gvrp vlan create
Parameters
None.
Default
By default, this option is enabled.