D-Link DGS-1510 Series - Page 277

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
274
Switch# show gvrp configuration interface eth3/0/5-3/0/6
eth3/0/5
GVRP Status : Enabled
Join Time : 20 centiseconds
Leave Time : 60 centiseconds
Leave-All Time : 1000 centiseconds
Advertise VLAN : 1-4094
Forbidden VLAN : 3-5
eth3/0/6
GVRP Status : Enabled
Join Time : 20 centiseconds
Leave Time : 60 centiseconds
Leave-All Time : 1000 centiseconds
Advertise VLAN : 1-3
Forbidden VLAN : 5-8
Switch#
31-9 show gvrp statistics
This command is used to display the statistics for a GVRP port.
show gvrp statistics [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID [, | -]
(Optional) Specifies the interfaces. Specify a single interface, a
range of interfaces separated by a hyphen, or a series of interfaces
separated by commas.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command only displays the ports which have the GVRP state enabled.
Example
This example shows how to display statistics for GVRP interfaces eth3/0/5 to eth3/0/6.