D-Link DGS-1510 Series - Page 294

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
291
Level: 1.
Usage Guideline
Use this command to display IGMP snooping group information.
Example
This example shows how to display IGMP snooping group information.
Switch# show ip igmp snooping groups
IGMP Snooping Connected Group Membership:
VLAN ID Group address Source address FM Exp(sec) Interface
------- --------------- --------------- -- -------- ---------
1 239.255.255.250 * EX 382 2/0/7
Total Entries: 1
Switch#
33-18 show ip igmp snooping mrouter
This command is used to display IGMP snooping router port information learned and configured on
the Switch.
show ip igmp snooping mrouter [vlan VLAN-ID]
Parameters
vlan VLAN-ID
(Optional) Specifies the VLAN. If no VLAN is specified, IGMP
snooping information on all VLANs will be displayed of which IGMP
snooping is enabled.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display dynamically learned or manually configured multicast router interfaces.
Example
This example shows how to display IGMP snooping router port information.