D-Link DGS-1510 Series - Page 302

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
299
txSTPDropPkts : 0
txHOLDropPkts : 0
dot3StatsAlignmentErrors : 0
dot3StatsFCSErrors : 0
dot3StatsSingleColFrames : 0
dot3StatsMultiColFrames : 0
dot3StatsSQETestErrors : 0
dot3StatsDeferredTransmisions : 0
dot3StatsLateCollisions : 0
dot3StatsExcessiveCollisions : 0
dot3StatsInternalMacTransmitErrors : 0
dot3StatsCarrierSenseErrors : 0
dot3StatsFrameTooLongs : 0
dot3StatsInternalMacReceiveErrors : 0
linkChange : 1
Switch#
34-6 show interfaces
This command is used to display the interface information.
show interfaces [INTERFACE-ID [- | ,]]
Parameters
INTERFACE-ID
(Optional) Specifies that the interface can be a physical port, VLAN,
or other.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If no interface is specified, all existing physical ports will be displayed.
Example
This example shows how to display the VLAN interface information for interface VLAN 1.
Switch# show interfaces vlan1
VLAN1 is enabled, link status is down
Interface type: VLAN
Interface description: VLAN 1 for MIS
MAC address: 08-00-01-22-00-00
Switch#