D-Link DGS-1510 Series - Page 307

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
304
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the Switch’s physical port utilization.
Example
This example shows how to display the Switch’s port utilization.
Switch# show interfaces utilization
Port TX packets/sec RX packets/sec Utilization
----------- ------------- -------------- -----------
eth1/0/1 0 0 0
eth1/0/2 1488109 0 50
eth1/0/3 0 0 0
eth1/0/4 0 1488109 50
eth1/0/5 0 0 0
eth1/0/6 0 0 0
eth1/0/7 0 0 0
eth1/0/8 0 0 0
Total Entries: 8
Switch#
34-10 show interfaces auto-negotiation
This command is used to display detailed auto-negotiation information of physical port interfaces.
show interfaces [INTERFACE-ID [,|-]] auto-negotiation
Parameters
auto-negotiation
Specifies to display detailed auto-negotiation information.
INTERFACE-ID
(Optional) Specifies the interface ID. If no interface is specified, the
auto-negotiation information on all physical port interfaces will be
displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the auto-negotiation information.