Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
The command is used to display the entries of the binding table.
Example
This example shows how to display the specified entries of the binding table.
Switch# show ipv6 neighbor binding
Codes: D - DHCPv6 Snooping, S - Static, N - ND Snooping
IPv6 address MAC address Interface VLAN Time left
N FE80::A8BB:CCFF:FE01:F500 AABB.CC01.F500 eth0/0 100 8850
S FE80::21D:71FF:FE99:4900 001D.7199.4900 eth0/1 100 N/A
N 2001:600::1 AABB.CC01.F500 eth0/0 100 3181
D 2001:300::1 AABB.CC01.F500 port-channel3 100 9559
D 2001:100::2 AABB.CC01.F600 eth1/0 200 9196
D 2001:400::1 001D.7199.4900 eth1/2 100 1568
S 2001:500::1 000A.000B.000C eth2/13 300 N/A
Switch#
Display Parameters