D-Link DGS-1510 Series - Page 35

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
32
3-11 dot1x timeout
This command is used to configure IEEE 802.1X timers. Use the no form of this command to revert a
specific timer setting to the default setting.
dot1x timeout {server-timeout SECONDS | supp-timeout SECONDS | tx-period SECONDS}
no dot1x timeout {server-timeout | supp-timeout | tx-period}
Parameters
server-timeout SECONDS
Specifies the number of seconds that the Switch will wait for the
request from the authentication server before timing out the server.
On timeout, authenticator will send EAP-Request packet to client.
The range is 1 to 65535.
supp-timeout SECONDS
Specifies the number of seconds that the Switch will wait for the
response from the supplicant before timing out the supplicant
messages other than EAP request ID. The range is 1 to 65535
tx-period SECONDS
Specifies the number of seconds that the Switch will wait for a
response to an EAP-Request/Identity frame from the supplicant
before retransmitting the request. The range is 1 to 65535
Default
The server-timeout is 30 seconds.
The supp-timeout is 30 seconds.
The tx-period is 30 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for physical port interface configuration.
Example
This example shows how to configure the server timeout value, supplicant timeout value, and the TX
period on Ethernet port 1/0/1 to be 15, 15, and 10 seconds, respectively.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# dot1x timeout server-timeout 15
Switch(config-if)# dot1x timeout supp-timeout 15
Switch(config-if)# dot1x timeout tx-period 10
Switch(config-if)#
3-12 show dot1x
This command is used to display the IEEE 802.1X global configuration or interface configuration.
show dot1x [interface INTERFACE-ID [, | -]]
Parameters