D-Link DGS-1510 Series - Page 365

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
362
Level: 12.
Usage Guideline
This is a global control for the LLDP forward. When the LLDP global state is disabled and LLDP
forwarding is enabled, the received LLDPDU packet will be forwarded.
Example
This example shows how to enable the LLDP global forwarding state.
Switch# configure terminal
Switch(config)# lldp forward
Switch(config)#
43-13 lldp tlv-select
This command is used to select the Type-Length-Value (TLVs) in the 802.1AB basic management set,
will be transmitted and encapsulated in the LLDPDUs, and sent to neighbor devices. Use the no form
of this command to disable this option.
lldp tlv-select [port-description | system-capabilities | system-description | system-name]
no lldp tlv-select [port-description | system-capabilities | system-description | system-name]
Parameters
port-description
(Optional) Specifies the port description TLV to send. The port
description TLV allows network management to advertise the IEEE
802 LAN station’s port description.
system-capabilities
(Optional) Specifies the system capabilities TLV to send. The
system capabilities field will contain a bit-map of the capabilities that
defines the primary functions of the system.
system-description
(Optional) Specifies the system description TLV to send. The
system description should include the full name and version
identification of the system’s hardware type, software operating
system, and networking software.
system-name
(Optional) Specifies the system name TLV to send. The system
name should be the system’s fully qualified domain name.
Default
No optional 802.1AB basic management TLV is selected.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to select the optional
TLVs to be transmitted. If the optional TLVs advertisement is selected, they will be encapsulated in
the LLDPDU and sent to other devices.
Example
This example shows how to enable all supported optional 802.1AB basic management TLVs.