D-Link DGS-1510 Series - Page 37

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
34
Parameters
interface INTERFACE-ID
(Optional) Specifies to display the dot1x diagnostics on the
specified interface or range of interfaces. If not specified,
information about all interfaces will be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display 802.1X diagnostics. Using this command without parameters
will display information about all interfaces. Otherwise, the diagnostics on the specified interface will
be displayed.
Example
This example shows how to display the dot1X diagnostics on Ethernet port 1/0/1.
Switch# show dot1x diagnostics interface eth1/0/1
eth1/0/1 dot1x diagnostic information are following:
EntersConnecting : 20
EAP-LogoffsWhileConnecting : 0
EntersAuthenticating : 0
SuccessesWhileAuthenticating : 0
TimeoutsWhileAuthenticating : 0
FailsWhileAuthenticating : 0
ReauthsWhileAuthenticating : 0
EAP-StartsWhileAuthenticating : 0
EAP-LogoffsWhileAuthenticating : 0
ReauthsWhileAuthenticated : 0
EAP-StartsWhileAuthenticated : 0
EAP-LogoffsWhileAuthenticated : 0
BackendResponses : 0
BackendAccessChallenges : 0
BackendOtherRequestsToSupplicant : 0
BackendNonNakResponsesFromSupplicant : 0
BackendAuthSuccesses : 0
BackendAuthFails : 0
Switch#
3-14 show dot1x statistics
This command is used to display IEEE 802.1X statistics. If no interface is specified, information about
all interfaces will be displayed.