D-Link DGS-1510 Series - Page 378

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
375
Tagged : -
Inventory Management :
(None)
Switch#
This example shows how to display remote LLDP information in the normal mode.
Switch# show lldp neighbor interface eth3/0/1
Port ID : 1
----------------------------------------------------------------------
Remote Entities Count : 2
Entity 1
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-01
Port ID Subtype : Local
Port ID : eth3/0/1
Port Description : RMON Port 3 on Unit 1
System Name : Switch1
System Description : Stackable Ethernet Switch
System Capabilities Supported : Repeater, Bridge
System Capabilities Enabled : Repeater, Bridge
Management Address Count : 1
Port VLAN ID : 1
PPVID Entries Count : 5
VLAN Name Entries Count : 3
Protocol ID Entries Count : 2
MAC/PHY Configuration Status : (See Detail)
Power Via MDI : (See Detail)
Link Aggregation : (See Detail)
Maximum Frame Size : 1536
LLDP-MED capabilities : (See Detail)
Network policy : (See Detail)
Extended Power Via MDI : (See Detail)
Inventory Management : (See Detail)
Unknown TLVs Count : 2
Entity 2
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-02
Port ID Subtype : Local
Port ID : eth2/0/1
Port Description : RMON Port 1 on Unit 2
System Name : Switch2
System Description : Stackable Ethernet Switch
System Capabilities Supported : Repeater, Bridge
System Capabilities Enabled : Repeater, Bridge
Management Address Count : 2
Port VLAN ID : 1
PPVID Entries Count : 5
VLAN Name Entries Count : 3
Protocol Id Entries Count : 2
MAC/PHY Configuration Status : (See Detail)
Power Via MDI : (See Detail)
Link Aggregation : (See Detail)
Maximum Frame Size : 1536
LLDP-MED capabilities : (See Detail)