D-Link DGS-1510 Series - Page 381

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
378
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays LLDP traffic on each physical interface.
Example
This example shows how to display statistics information of port 1.
Switch#show lldp traffic interface ethernet 1/0/1
Port ID : eth1/0/1
---------------------------------------------
Total Transmits : 0
Total Discards : 0
Total Errors : 0
Total Receives : 0
Total TLV Discards : 0
Total TLV Unknowns : 0
Total Ageouts : 0
Switch#
Display Parameters
Total Transmits
The total number of LLDP packets transmitted on the port.
Total Discards
The total number of LLDP frames discarded on the port for any
reason.
Total Errors
The number of invalid LLDP frames received on the port.
Total Receives
The total number of LLDP packets received on the port.
Total TLV Discards
The number of TLVs discarded.
Total TLV Unknowns
The total number of LLDP TLVs received on the port where the type
value is in the reserved range, and not recognized.
Total Ageouts
The total number of times a complete remote data entry was
deleted for the port because the Time to Live interval expired.