D-Link DGS-1510 Series - Page 386

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
383
Switch# show loopback-detection interface eth1/0/1
Interface Result Time Left(sec)
------------- ------------------ ------------
eth1/0/1 Normal -
Switch#
This example shows how to displays the loopback detection status for port-channel 2.
Switch# show loopback-detection interface port-channel2
Interface Result Time Left(sec)
------------- ------------------ ------------
Po2 Normal -
Switch#
Display Parameters
Interface
Indicates the port that has loopback detection enabled.
Result
Indicates whether a loop is detected.
Time Left
The remaining time before being auto-recovered.
44-6 snmp-server enable traps loopback-detection
This command is used to enable the sending SNMP notifications of loopback detection. Use the no
form of this command to revert to the default setting.
snmp-server enable traps loopback-detection
no snmp-server enable traps loopback-detection
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable or disable the sending SNMP notifications of loopback detection.
Example
This example shows how to enable the sending SNMP notifications of loopback detection.