D-Link DGS-1510 Series - Page 39

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
36
Parameters
interface INTERFACE-ID
(Optional) Specifies to display the dot1x diagnostics on the
specified interface or range of interfaces. If not specified,
information about all interfaces will be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display 802.1X session statistics. Using this command without
parameters will display information about all interfaces. Otherwise, the session statistics on the
specified interface will be displayed.
Example
This example shows how to display dot1X session statistics on Ethernet port 1/0/1.
Switch# show dot1x session-statistics interface eth1/0/1
eth6/0/1 session statistic counters are following:
SessionOctetsRX : 0
SessionOctetsTX : 0
SessionFramesRX : 0
SessionFramesTX : 0
SessionId :
SessionAuthenticationMethod : Remote Authentication Server
SessionTime : 0
SessionTerminateCause :SupplicantLogoff
SessionUserName :
Switch#
3-16 snmp-server enable traps dot1x
This command is used to enable sending SNMP notifications for 802.1X authentication. Use the no
form of this command to disable sending SNMP notifications.
snmp-server enable traps dot1x
no snmp-server enable traps dot1x
Parameters
None.
Default