D-Link DGS-1510 Series - Page 394

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
391
monitor session SESSION-NUMBER source acl ACCESS-LIST-NAME
no monitor session SESSION-NUMBER source acl ACCESS-LIST-NAME
Parameters
session SESSION-NUMBER
Specifies the session number for the port monitor session. The valid
range is 1 to 4.
acl ACCESS-LIST-NAME
Specifies the flow-based mirror.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Multiple access lists can be monitored on a session at a time.
Example
This example shows how to create a monitor session with the session number 2. It assigns the MAC
access list MAC-Monitored-flow as the monitor source.
Switch# configure terminal
Switch(config)# monitor session 2 destination interface ethernet1/0/1
Switch(config)# monitor session 2 source acl MAC-Monitored-flow
Switch(config)#
46-4 show monitor session
This command is used to display all or a specific port mirroring session.
show monitor session [SESSION-NUMBER]
Parameters
SESSION-NUMBER
(Optional) Specifies the session number which you want to display.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If this command is used without specifying a session number, all monitor sessions are displayed.
Example
This example shows how to display a created port monitor session with the session number 1.