DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
416
48-9 spanning-tree mst priority
This command is used to configure the bridge priority value for the selected MSTP instance. Use the
no form of this command to revert to the default setting.
spanning-tree mst INSTANCE-ID priority PRIORITY
no spanning-tree mst INSTANCE-ID priority
Parameters
Specifies the MSTP instance identifier. Instance 0 represents the
default instance, CIST.
Specifies the bridge priority value that must be divisible by 4096.
The range is from 0 to 61440.
Default
By default, this value is 32768.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The priority has same meaning with as the bridge priority in the STP command reference, but can
specify a different priority for distinct MSTP instances.
Example
This example shows how to configure the bridge priority for the MSTP instance 2.
Switch# configure terminal
Switch(config)# spanning-tree mst 2 priority 0
Switch(config)#
To Next Page
Loading...
