D-Link DGS-1510 Series - Page 42

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
39
Switch# configure terminal
Switch(config)# show access-list ip R&D
Extended IP access list R&D(ID: 3552)
10 permit tcp any 10.20.0.0 255.255.0.0
20 permit tcp any host 10.100.1.2
30 permit icmp any any
Switch(config)# ip extended access-list R&D
Switch(config-ip-ext-acl)# 5 permit tcp any 10.30.0.0 255.255.0.0
Switch(config-ip-ext-acl)# exit
Switch(config)# show access-list ip R&D
Extended IP access list R&D(ID: 3552)5 permit tcp any 10.30.0.0 255.255.0.0
10 permit tcp any 10.20.0.0 255.255.0.0
20 permit tcp any host 10.100.1.2
30 permit icmp any any
Switch(config)# access-list resequence R&D 1 2
Switch(config)# show access-list ip R&D
Extended IP access list R&D(ID: 3552)
1 permit tcp any 10.30.0.0 255.255.0.0
3 permit tcp any 10.20.0.0 255.255.0.0
5 permit tcp any host 10.100.1.2
7 permit icmp any any
Switch(config)#
4-2 acl-hardware-counter
This command is used to enable the ACL hardware counter of the specified access-list name for
access group functions or access map for the VLAN filter function. Use the no form of this command
to disable the ACL hardware counter function.
acl-hardware-counter {access-group {ACCESS-LIST-NAME | ACCESS-LIST-NUMBER} | vlan-
filter ACCESS-MAP-NAME}
no acl-hardware-counter {access-group {ACCESS-LIST-NAME | ACCESS-LIST-NUMBER} |
vlan-filter ACCESS-MAP-NAME}
Parameters
access-group ACCESS-LIST-
NAME
Specifies the name of the access list to be configured.
access-group ACCESS-LIST-
NUMBER
Specifies the number of the access list to be configured.
vlan-filter ACCESS-MAP-
NAME
Specifies the name of the access map to be configured.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline