Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the policy name is specified, only the specified policy information is displayed. If the policy name is
not specified, information is displayed for all policies.
Example
This example shows how to display the policy configuration for a policy named “inspect1” and all the
interfaces where the policy is applied:
Switch# show ipv6 nd inspection policy inspect1
Policy inspect1 configuration:
Device Role: host
Validate Source MAC: Enabled
Target: eth1/0/1-1/0/2
Switch#
To Next Page
Loading...
