D-Link DGS-1510 Series - Page 434

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
431
show authentication sessions [mac | wac | jwac | dot1x | interface INTERFACE-ID [, | -] [mac
| wac | jwac | dot1x] | mac-address MAC-ADDRESS]
Parameters
mac
(Optional) Specifies to display all MAC sessions.
wac
(Optional) Specifies to display all WAC sessions.
wac
(Optional) Specifies to display all JWAC sessions.
dot1x
(Optional) Specifies to display all dot1x sessions.
interface INTERFACE-ID
(Optional) Specifies a port to display.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
mac-address MAC-ADDRESS
(Optional) Specifies to display a specific user.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command without parameters to display the sessions associated with all ports.
Example
This example shows how to display sessions on Ethernet port 1/0/1.
Switch# show authentication sessions interface eth1/0/1
Interface: eth1/0/1
MAC Address: 00-16-76-35-1A-38
Authentication VLAN: 1
Authentication State: Success
Accounting Session ID: 0000000000CB
Authentication Username: wac
Client IP Address: 10.90.90.9
Aging Time: 3590 sec
Method State
WEB-based Access Control: Success, Selected
Total Authenticating Hosts: 0
Total Authenticated Hosts: 1
Total Blocked Hosts: 0
Switch#
Display Parameters
Interface
The authentication host received interface.