D-Link DGS-1510 Series - Page 439

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
436
no ntp authentication-key KEY-ID
Parameters
KEY-ID
Specifies the NTP key ID. The value is from 1 to 255.
md5
Specifies the authentication key type to MD5.
VALUE
Specifies the key string. This string must be 32 characters long.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to define an authentication key for NTP. Use the no form of this command to
remove the key.
Example
This example shows how to define an authentication key with the key ID “45” and key string “NTPKey”.
Switch#configure terminal
Switch(config)#ntp authentication-key 45 md5 NTPKey
Switch(config)#
51-4 ntp control-key
This command is used to define the key ID for the NTP control messages. Use the no form of this
command to remove the key.
ntp control-key KEY-ID
no ntp control-key
Parameters
KEY-ID
Specifies the NTP key ID. The value is from 1 to 255.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to define the key ID for the NTP control messages. Use the no form of this
command to remove the key.
Example
This example shows how to define a key ID for the NTP control messages.