D-Link DGS-1510 Series - Page 441

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
438
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure RTC as an NTP master clock when an external NTP is not
available. Use the no form of this command to disable this feature.
Example
This example shows how to configure a router as an NTP master clock.
Switch#configure terminal
Switch(config)#ntp master 10
Switch(config)#
51-7 ntp max-associations
This command is used to configure the maximum number of NTP peers and clients on the Switch.
Use the no form of this command to revert to the default setting.
ntp max-associations NUMBER
no ntp max-associations
Parameters
NUMBER
Specifies the number of NTP associations. This value must be
between 1 and 64.
Default
By default, the value is 32.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the maximum number of NTP peers and clients on the Switch.
Use the no form of this command to revert to the default setting.
Example
This example shows how to configure the maximum number of NTP associations to 20.
Switch#configure terminal
Switch(config)#ntp max-associations 20
Switch(config)#
51-8 ntp peer
This command is used to configure the NTP peer settings. Use the no form of this command to
disable this feature.