D-Link DGS-1510 Series - Page 462

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
459
only available, if stacking is enabled.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable sending PoE usage threshold exceeding traps.
Example
This example shows how to enable trap for PoE event.
Switch#configure terminal
Switch(config)#snmp-server enable traps poe
Switch(config)#
53-8 clear poe statistic
This command is used to clear the statistic counters on the port.
clear poe statistic {all | interface INTERFACE-ID [,|-]}
Parameters
all
Specifies to clear PoE statistics for all interfaces.
interface INTERFACE-ID
Specifies the interface ID of an interface.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
There are counters on ports to record the statistic and they can be shown by show poe power-inline
statistics command. Use this command to clear all the counter values on the port.
Example
This example shows how to clear statistics on interface eth3/0/1.