DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
469
Example
This example shows how to enable the EEE power saving function.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# power-saving eee
Switch(config-if)#
54-4 power-saving dim-led time-range
This command is used to configure the time range profile for the dim LED schedule. Use the no form
of this command to delete the specified time range profile.
power-saving dim-led time-range PROFILE-NAME
no power-saving dim-led time-range PROFILE-NAME
Parameters
Specifies the name of the time range profile to be configured. The
maximum length is 32 characters.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add or delete a time range profile for the dim LED schedule. When the schedule
is up, all port’s LED will be turned off.
Example
This example shows how to add a time-range profile for the dim LED schedule.
Switch# configure terminal
Switch(config)# power-saving dim-led time-range off-duty
Switch(config)#
54-5 power-saving hibernation time-range
This command is used to configure the time range profile for the system hibernation schedule. Use
the no form of this command to delete the specified time range profile.
power-saving hibernation time-range PROFILE-NAME
no power-saving hibernation time-range PROFILE-NAME
Parameters
Specifies the name of the time range profile to be configured. The
To Next Page
Loading...
