D-Link DGS-1510 Series - Page 484

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
481
cos COS-LIST
Specifies a specific IEEE 802.1Q CoS value(s) to be matched. The
COS-LIST parameter values are from 0 to 7. Enter one or more
CoS values separated by commas or hyphen for a range list.
[ip] dscp DSCP-LIST
Specifies differentiated service code point values to be matched.
Enter one or more differentiated service code point (DSCP) values
separated by commas or hyphen for a range list. The valid range is
from 0 to 63.
(Optional) ip - Specifies that the match is for IPv4 packets only. If
not specified, the match is for both IPv4 and IPv6 packets.
[ip] precedence IP-
PRECEDENCE-LIST
Specifies IP precedence values to be matched. Enter one or more
precedence values separated by commas or hyphen for a range
list. The valid range is from 0 to 7.
(Optional) ip - Specifies that the match is for IPv4 packets only. If
not specified, the match is for both IP and IPv6 packets. For IPv6
packets, the precedence is most three significant bits of traffic class
of IPv6 header.
protocol PROTOCOL-NAME
Specifies the protocol name to be matched.
vlan VLAN-ID-LIST
Specifies the VLAN identification number, numbers, or range of
numbers to be matched. Valid VLAN identification numbers must be
in the range of 1 to 4094. Enter one or more VLAN values
separated by commas or hyphens for a range list.
Default
None.
Command Mode
Class-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
To use the match command, first enter the class-map command to specify the name of the class that
will be used to establish the match criteria. The policy for handling these matched packets is defined
in the policy-map class configuration mode.
The following lists the reference for the supported protocols for the match protocol command.
 arp - IP Address Resolution Protocol (ARP).
 bgp - Border Gateway Protocol.
 dhcp - Dynamic Host Configuration.
 dns - Domain Name Server lookup.
 egp - Exterior Gateway Protocol.
 ftp - File Transfer Protocol.
 ip - IP (version 4).
 ipv6 - IP (version 6).
 netbios - NetBIOS.
 nfs - Network File System.
 ntp - Network Time Protocol.
 ospf - Open Shortest Path First.
 pppoe - Point-to-Point Protocol over Ethernet.
 rip - Routing Information Protocol.
 rtsp - Real-Time Streaming Protocol.
 ssh - Secured shell.
 telnet - Telnet.
 tftp - Trivial File Transfer Protocol.
Example
This example shows how to specify a class map called “class-home-user” and configures the access
list named “acl-home-user” to be used as the match criterion for that class.