D-Link DGS-1510 Series - Page 506

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
503
rate-limit
Specifies to displays the bandwidth limitation configured for the port.
queue-rate-limit
Specifies to displays the bandwidth allocation configured for the
queue.
dscp-mutation
Specifies to displays the DSCP mutation map attached to the
interface.
map dscp-color
Specifies to displays the DSCP to color map.
map cos-color
Specifies to displays the CoS to color map.
map dscp-cos
Specifies to displays the mapping of DSCP to CoS.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display port level QoS configurations.
Example
This example shows how to display the default CoS for eth 1/0/2 to eth 1/0/5.
Switch# show mls qos interface eth1/0/2-5 cos
Interface CoS Override
---------- ---- ---------
eth1/0/2 3 Yes
eth1/0/3 4 No
eth1/0/4 4 No
eth1/0/5 3 No
Switch#
This example shows how to display the port trust state for eth 1/0/2 to eth 1/0/5.
Switch# show mls qos interface eth1/0/2-1/0/5 trust
Interface Trust State
---------- ------------
eth1/0/2 trust DSCP
eth1/0/3 trust CoS
eth1/0/4 trust DSCP
eth1/0/5 trust CoS
Switch#
This example shows how to display the scheduling configuration for eth1/0/1 to eth1/0/2.