D-Link DGS-1510 Series - Page 51

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
48
Usage Guideline
If MAC access group is already configured on the interface, the command applied later will overwrite
the previous setting. MAC access-groups will only check non-IP packets.
Only one access list of the same type can be applied to the same interface; but access lists of
different types can be applied to the same interface.
The association of an access group with an interface will consume the filtering entry resource in the
switch controller. If the resource is insufficient to commit the command, then an error message will be
displayed.
Example
This example shows how to apply the MAC access list daily-profile to Ethernet port 5/0/1.
Switch# configure terminal
Switch(config)# interface eth5/0/1
Switch(config-if)# mac access-group daily-profile in
The remaining applicable MAC access entries are 204
Switch(config-if)#
4-13 mac access-list
This command is used to create or modify an MAC access list and this command will enter the MAC
access list configuration mode. Use the no form of this command to delete a MAC access list.
mac access-list extended NAME [NUMBER]
no mac access-list extended {NAME | NUMBER}
Parameters
NAME
Specifies the name of the MAC access-list to be configured. The
maximum length is 32 characters.
NUMBER
Specifies the ID number of the MAC access list, For extended MAC
access lists, this value is from 6000 to 7999.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter the MAC access-list configuration mode and use the permit or deny
command to specify the entries. The name must be unique among all access lists. The characters of
the name are case sensitive. If the access list number is not specified, the biggest unused number in
the range of the MAC access list numbers will be assigned automatically.
Example
This example shows how to enter the MAC access list configuration mode for a MAC access list
named “daily profile”.
Switch# configure terminal
Switch(config)# mac access-list extended daily-profile
Switch(config-mac-ext-acl)#