D-Link DGS-1510 Series - Page 55

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
52
WILDCARD
bitmap. The bit corresponding to the bit value 1 will be ignored. The
bit corresponding to the bit value 0 will be checked.
host DST-IP-ADDR
Specifies a specific destination host IP address.
DST-IP-ADDR DST-IP-
WILDCARD
Specifies a group of destination IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The
bit corresponding to the bit value 0 will be checked.
precedence PRECEDENCE
(Optional) Specifies that packets can be filtered by precedence
level, as specified by a number from 0 to 7.
tos TOS
(Optional) Specifies that packets can be filtered by type of service
level, as specified by a number from 0 to 15.
dscp DSCP
(Optional) Specifies the matching DSCP code in IP header. The
range is from 0 to 63, or select the following DSCP name: af11 -
001010, af12 -001100, af13 - 001110, af21 - 010010, af22 -
010100, af23 - 010110, af31 - 011010, af32 - 011100, af33 -
011110, af41 - 100010, af42 - 100100, af43 - 100110, cs1 -
001000, cs2 - 010000, cs3 - 011000, cs4 - 100000, cs5 - 101000,
cs6 - 110000, cs7 - 111000, default - 000000, ef – 101110.
lt PORT
(Optional) Specifies to match if less than the specified port number.
gt PORT
(Optional) Specifies to match if greater than the specified port
number.
eq PORT
(Optional) Specifies to match if equal to the specified port number.
neq PORT
(Optional) Specifies to match if not equal to the specified port
number.
range MIN-PORT MAX-PORT
(Optional) Specifies to match if fall within the range of ports.
TCP-FLAG
(Optional) Specifies the TCP flag fields and the specified TCP
header bits called ack (acknowledge), fin (finish), psh (push), rst
(reset), syn (synchronize), or urg (urgent).
fragments
(Optional) Specifies the packet fragment’s filtering.
time-range PROFILE-NAME
(Optional) Specifies the name of time period profile associated with
the access list delineating its activation period.
ICMP-TYPE
(Optional) Specifies the ICMP message type. The valid number for
the message type is from 0 to 255.
ICMP-CODE
(Optional) Specifies the ICMP message code. The valid number for
the message code is from 0 to 255.
ICMP-MESSAGE
(Optional) Specifies the ICMP message. The following pre-defined
parameters are available for selection: beyond-scope, destination-
unreachable, echo-reply, echo-request, header, hop-limit, mld-
query, mld-reduction, mld-report, nd-na, nd-ns, next-header, no-
admin, no-route, packet-too-big, parameter-option, parameter-
problem, port-unreachable, reassembly-timeout, redirect, renum-
command, renum-result, renum-seq-number, router-advertisement,
router-renumbering, router-solicitation, time-exceeded,
unreachable.
Default
None.
Command Mode
Extended Expert Access-list Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline