DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
556
63-9 snmp-server name
This command is used to configure the system’s name information. Use the no form of this command
to remove the setting.
snmp-server name NAME
no snmp-server name
Parameters
Specifies the string that describes the SNMP server name
information. The maximum length is 64 characters. This name
should start with a letter, and end with a letter or a number.
Hyphens are allowed to be used in between the starting and ending
characters. It is recommended not to configure the name longer
than 10 characters.
Default
By default, this name is “Switch”.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the system’s name information on the Switch.
Example
This example shows how to configure the system’s name to “SiteA-switch”.
Switch#configure terminal
Switch(config)#snmp-server name SiteA-switch
SiteA-switch(config)#
63-10 snmp-server trap-sending disable
This command is used to disable the port’s trap sending state. Use the no form of this command to
disable the port’s trap sending state.
snmp-server trap-sending disable
no snmp-server trap-sending disable
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
To Next Page
Loading...
