D-Link DGS-1510 Series - Page 562

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
559
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# no snmp trap link-status
Switch(config-if)#
63-14 show snmp
This command is used to display the SNMP settings.
show snmp {community | host | view | group | engineID}
Parameters
community
Specifies to display SNMP community information.
host
Specifies to display SNMP trap recipient information.
view
Specifies to display SNMP view information.
group
Specifies to display SNMP group information.
engineID
Specifies to display SNMP local engine ID information.
Default
None.
Command Mode
Privileged EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command displays the SNMP information. When displaying SNMP community strings, the
SNMPv1 or SNMPv2c user created will not be displayed.
Example
This example shows how to display SNMP community information.
Switch# show snmp community
Codes: ro - read only, rw – Read Write
Community access view
------------------ ---- -----------------------------------------------------------
-
System rw sales-divison checked with IP access control list:
SalesDvision
public ro RD-division checked with IP access control list: HB5
Develop ro RD2
private rw Line2 checked with IP access control list: HQ
Total Entries: 4
Switch#
This example shows how to display the SNMP server host setting.