DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
571
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
There are 3 roles in the single IP management system: Candidate, Commander and Member.
The roles of Candidate and Commander can be specified by the user. The Member role can be
specified by the command sim group-member on the commander switch.
The SIM group consists of the Commander switch and many member switches If the switch roles
change, like Commander to Candidate, all of the members in the SIM group will be changed to
Candidate.
Example
This example shows how to create a single IP management group.
Switch# configure terminal
Switch(config)# sim role commander my-group
Switch(config)#
64-3 sim group-member
This command is used to add one Candidate switch to the single IP management group. Use the no
form of this command to remove one member from this single IP management group.
sim group-member CANDIDATE-ID [PASSWORD]
no sim group-member MEMBER-ID
Parameters
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
On the Commander switch, the Candidate switch can be joined to the group and it will be changed to
the member switch. The Commander switch must pass the Candidate switch Level-15 password
authentication.
Example
This example shows how to add one candidate switch to the single IP management group.
Switch# configure terminal
Switch(config)# sim group-member 1 secret
Switch(config)#
To Next Page
Loading...
