D-Link DGS-1510 Series - Page 579

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
576
This example shows how to enable sending single IP management trap.
Switch# configure terminal
Switch(config)# snmp-server enable traps sim
Switch(config)#
64-10 show sim
This command is used to display single IP management information.
show sim [{candidates [CANDIDATE-ID] | members [MEMBER-ID] | group [COMMANDER-
MAC] | neighbor}]
Parameters
candidates
Specifies to display the information of Candidate switches.
CANDIDATE-ID
Specifies to display detailed information of a Candidate.
members
Specifies to display the information of Member switches.
MEMBER-ID
Specifies to display detailed information of a Member.
group
Specifies to display the information of other SIM Groups.
COMMANDER-MAC
Specifies to display detailed information of a Group.
neighbor
Specifies to display the neighbor information.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display single IP management information.
Example
This example shows how to display detailed local SIM information on the Commander.
Switch#show sim
SIM Version : VER-1.61
Firmware Version : 1.30.003
Management VLAN : 1
Device Name : Switch
MAC Address : 3C-1E-04-A1-CC-00
Platform : DGS-1510-28XMP
SIM State : Disabled
Role State : Candidate
Discovery Interval : 30 sec
Hold Time : 100 sec
Switch#
This example shows how to display detailed local SIM information on the Member switch.