D-Link DGS-1510 Series - Page 598

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
595
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable sending of stacking related traps.
Example
This example shows how to enable sending of stacking related traps.
Switch# configure terminal
Switch(config)# snmp-server enable traps stack
Switch(config)#
66-6 show stack
This command is used to display the stacking information.
show stack
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the stacking information.
Example
This example shows how to display stacking information.