DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
604
Both the surveillance vlan command in Global Configuration Mode and the surveillance vlan
enable command in Interface Configuration Mode need to be enabled for a port to start the
surveillance VLAN function.
When surveillance VLAN is enabled for a port, the port will be automatically learned as surveillance
VLAN untagged member, the received untagged surveillance packets will be forwarded to
surveillance VLAN. The received packets are determined as surveillance packets if the source MAC
addresses of packets comply with the organizationally unique identifier (OUI) addresses configured by
the surveillance vlan mac-address command.
Example
This example shows how to enable surveillance VLAN function on physical port eth1/0/1.
Switch# configure terminal
Switch(config)#interface eth1/0/1
Switch(config-if)#surveillance vlan enable
Switch(config-if)#
68-4 surveillance vlan mac-address
This command is used to add the user-defined surveillance device OUI. Use the no form of this
command to delete the user-defined surveillance device OUI.
surveillance vlan mac-address MAC-ADDRESS MASK [component-type {vms | vms-client |
video-encoder | network-storage | other} description TEXT]
no surveillance vlan mac-address MAC-ADDRESS MASK
Parameters
To Next Page
Loading...
