D-Link DGS-1510 Series - Page 609

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
606
Switch# configure terminal
Switch(config)# surveillance vlan qos 7
Switch(config)#
68-6 show surveillance vlan
This command is used to display the surveillance VLAN configurations.
show surveillance vlan [ interface [ INTERFACE-ID [, | -] ] ]
show surveillance vlan device [ interface [ INTERFACE-ID [, | -] ] ]
Parameters
device
Specifies to display the learned surveillance devices information
interface
(Optional) Specifies to display surveillance VLAN information of
ports.
INTERFACE-ID
(Optional) Specifies the port to be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the surveillance VLAN configurations.
The show surveillance vlan command is used to display the surveillance VLAN global
configurations.
The show surveillance vlan interface command is used to display the surveillance vlan
configurations on the interfaces.
The show surveillance vlan device command is used to display the surveillance device discovered
by its OUI.
Example
This example shows how to displays the surveillance VLAN global settings.