D-Link DGS-1510 Series - Page 619

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
616
Switch# reset system
This command will clear all of system configuration as factory
default setting including IP parameters and stacking information.
Clear system configuration, save, reboot? (y/n) [n] y
Saving configurations and logs to NV-RAM...... Done.
Please wait, the switch is rebooting...
70-5 configure replace
This command is used to replace the current running configuration with the indicated configuration file.
configure replace {{tftp: //location/filename | flash: FILENAME} [force]
Parameters
tftp:
Specifies that the configuration file is from the TFTP server.
//location/filename
Specifies the URL of the configuration file on the TFTP server.
flash:
Specifies that the configuration file is from the NVRAM of the
device.
FILENAME
Specifies the name of the configuration file stored in the NVRAM.
force
(Optional) Specifies to execute the command immediately with no
confirmation needed.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to execute the indicated configuration file to replace the current running
configuration. The current running configuration will be cleared before applying the indicated
configuration.
NOTE: The command will replace the current running configuration with the contents of
the specified configuration file. So the specified configuration file is assumed to be a
complete configuration, not a partial configuration.
Before using the configure replace command, save a backup of the configuration using the copy
command or upload the configuration profile to the TFTP server.
Example
This example shows how to download the “config.cfg” from the TFTP server and replace the current
running configuration with it.