D-Link DGS-1510 Series - Page 63

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
60
interface INTERFACE-ID
(Optional) Specifies the interface to be displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If interface is not specified, all of the interfaces that have access list configured will be displayed.
Example
This example shows how to display access lists that are applied to all of the interfaces.
Switch# show access-group
eth1/0/1:
Inbound mac access-list : simple-mac-acl(ID: 7998)
Inbound ip access-list : simple-ip-acl(ID: 1998)
Switch#
4-22 show access-list
This command is used to display the access list configuration information.
show access-list [ip [NAME | NUMBER] | mac [NAME | NUMBER] | ipv6 [NAME | NUMBER] |
expert [NAME | NUMBER] | arp [NAME]]
Parameters
ip
(Optional) Specifies to display a listing of all IP access lists.
mac
(Optional) Specifies to display a listing of all MAC access lists.
ipv6
(Optional) Specifies to display a listing of all IPv6 access lists.
expert
(Optional) Specifies to display a listing of all expert access lists.
NAME | NUMBER
Specifies to display the contents of the specified access list.
arp
Specifies to display the ARP access list.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays access list information. If no option is specified, a listing of all configured
access lists is displayed. If the type of access list is specified, detailed information of the access list