D-Link DGS-1510 Series - Page 66

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
63
MAP-NAME
(Optional) Specifies the name of the VLAN access map. The name
can be up to 32 characters.
VLAN-ID
(Optional) Specifies the VLAN ID.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
The show vlan filter access-map command is used to display the VLAN filter information by access
map. The command show vlan filter vlan is used to display the VLAN filter information by VLAN.
Example
This example shows how to display VLAN filter information.
Switch# show vlan filter
VLAN Map aa
Configured on VLANs: 5-127,221-333
VLAN Map bb
Configured on VLANs: 1111-1222
Switch#
Switch# show vlan filter vlan 5
VLAN ID 5
VLAN Access Map: aa
Switch#
4-25 vlan access-map
This command is used to create a sub-map of a VLAN access map and enter the VLAN access-map
sub-map configure mode. The no form of this command used to delete an access-map or its sub-map.
vlan access-map MAP-NAME [SEQUENCE-NUM]
no vlan access-map MAP-NAME [SEQUENCE-NUM]
Parameters
MAP-NAME
Specifies the name of the VLAN access map to be configured. The
name can be up to 32 characters.
SEQUENCE-NUM
(Optional) Specifies the sequence number of the sub-map. The
valid range is from 1 to 65535.
Default
None.
Command Mode